How do you pronounce idss in English (1 out of 51).

Captions are loading...

Translation of idss

Translate idss to Go

IPA (International Phonetic Alphabet) of idss

The International Phonetic Alphabet (IPA) is an alphabetic system of phonetic notation based primarily on the Latin alphabet. With phonetic transcriptions, dictionarie tell you about the pronunciation of words, because the spelling of an English word does not tell you how you should pronounce it. Below is the phonetic transcription of idss:
a state in the Rocky Mountains
MeronymsLewiston, Twin Falls, Boise, Coeur d'Alene Lake, Snake, Idaho Falls, Nampa, Sun Valley, Coeur d'Alene, Pocatello, Yellowstone National Park, Salmon,
SynonymsGem State, Idaho, ID,
HolonymsUnited States,
a card or badge used to identify the bearer
  1. you had to show your ID in order to get in
Hypernymsbadge, positive identification,
SynonymsID, I.D.,
(psychoanalysis) primitive instincts and energies underlying all psychic activity
Holonymsunconscious mind,

idss on Youtube

  1. voltage between drain and source VDS, saturating value of that current is known as IDSS. IDSS
  2. is the IDSS. This current IDSS has the maximum value for this VGS is equal to zero and you
  3. only -1 by vP. We get 2 IDSS. Basically this will be 2 IDSS into 1 minus vGS by vP into
  4. all these together, into a term call IDSS. This is the term which matters the most, IDSS.
  5. Now what is that IDSS? IDSS is nothing but G0Vp0 by 4 and IDS is the saturation current.
  6. is equal to IDSS and the output impedance R0 is going to be rds.
  7. is pinching off. This maximum current ID is known as IDSS for VGS is equal to zero. This
  8. have in JFET device this is specified; IDSS will be specified.
  9. equal to zero and that is known as the IDSS current. This is the drain to source current
  10. equation gives you the value of the drain current which is given by IDSS into 1 minus
  11. is the trans-conductance gm. Here this IDSS and VP, these two are important parameters
  12. must know the value of pinch off voltage and the IDSS current. This will be generally given
  13. pinch off voltage and the IDSS written in the data sheet. These two are known for a
  14. versus voltage that it is a non-linear curve only. The value of ID depends on IDSS and
  15. current in the drain is known as IDSS. If we go on now increasing the gate to source
  16. GS is equal to zero volt, we have this IDSS as the saturation current. If we extend the
  17. volt VGS which is giving the zero drain current and the other maximum drain current is IDSS
  18. VGS in the positive direction. So the drain current is maximum at IDSS and minimum at
  19. So it is like this. This is IDSS and this is ID zero. If this is the Q point, around
  20. with VGS. What is that relation? That relation is iD equal to iDSS into 1 minus vGS by vP