Practice English Speaking&Listening with: HUBSAN ZINO 2 - HOW TO DETACH GIMBAL & REPLACE RIBBON FPC CABLE & HOW TO PAIRING TRANSMITTER
Okay, right now we will show you how to detach the gimbal/camera
Now we will remove the cover first
First we need to remove the two cover screw
cause the cover have a clip,
the cover is clip inside there, usually we just use the finger nail to remove it
some of them will be hard to remove, so you have to push hardly to remove it
after that still have four screw need to remove
at outside have two
inside the cover have two, so total was four screws need to remove
four of the screws was remove
pull it out from the cover side
but do not pull it hardly
cause under the gimbal have fpc cable connected with it
for this cable
use a tools to unplug it.
push it up
cable socket like this
that can't be remove cause you should remove the socket first
if you want to replace the fpc cable you should remove the cover.
just remove two screws only
after remove the screws
this cover will drop, so after remove the cover same step too
just push the plug up
so you can install back after get the new cable
just put at the right place and push it in
after that install the cable cover back
after that install the fpc cable to the main board
just push the plug to the socket
when push it
should push the side near the cable side do not push the other side cause it will be unplug
install back all the screws
okay, today we will teach how to
pairing the remote with the drone
okay, how do we need to pairing them
first, we should
at the drone there
you can find a small round hole at the left side of drone
okay
for the small hole, we want it
go to the pairing mode, so
for go to the pairing mode, you will see
this small hole, we press
press and hold
press and hold
okay, until
four of the light become twinkling
that mean it go into the pairing mode
should press and hold
until the light are twinkling, we on the transmitter/remote control
after on we go in to the apps
enter device
okay
when go into the apps
we go to the setting
go to
control
and go to the "set the connection between the aircraft and the transmitter"
go in
after that we press
after that we press refresh button
okay
after that, you will get a drone code
we press and choose it
we choose and press connect
okay
so it was pairing
you can see all of them, and the light are stop twinkling
so have the image
it was pairing
okay
we test
without connect with phone
and without insert the sd card
so
and take off indoor
so, like this is start
the motor was run, okay
like this
start the motor
if want to off
if want to off like this
off
right now, we
start first
okay motor already start, so now we take off
